220v IEC Test Equipment Tumbling Barrel Testing Machine With 19mm Thick Blockboard
|
220v IEC Test Equipment Tumbling Barrel Testing Machine With 19mm Thick Blockboard
Product information:
This tester is according to the standard of BS1363.1 clause 20, figure 20 to manufacture, which is used to do the drop test of the electrical accessories, in order to determine the dropping suitability of the product during transportation or the minimum firm level of security required for the determination of safety requirements.
Plugs shall have adequate mechanical strength and be so constructed as to withstand such handling as may be expected in normal use. Compliance shall be checked by tests given in 20.1.2 and 20.1.3. A solid link of stainless steel as shown in Figure 19 is inserted and withdrawn from the fuse clips of the plug 20 times in succession in a normal manner. Not in mis-use conditions, at a rate not exceeding 10 per minute. A standard fuse link complying with BS 1362:1973 is then fitted and the appropriate mechanical strength test completed. Rewirable plugs are fitted with 3-core PVC 1.25 mm² flexible cord as given in Table 27 of BS 6500:2000, the terminals and cover screws being tightened with the torque given in Table 3. Non-rewirable plugs are tested as delivered. Rewirable plugs with clamp type (screwless) terminals are fitted with 3-core PVC 1.25 mm²flexible cord as given in Table 27 of BS 6500:2000. The connection of the conductors shall be made in accordance with the manufacturer’s instructions. The flexible cords attached to plugs are cut to a length of 150 mm ±5 mm measured from the nearest edge of the earthing pin, precoiled flexible cords being extended before measurement. Plugs are tested in the tumbling barrel shown in Figure 20. The barrel is turned at a rate of approximately 5 r/min, (approximately 10 falls per minute). This tester is according to the standard of BS1363.1 clause 20, figure 20 to manufacture, which is used to do the drop test of the electrical accessories, in order to determine the dropping suitability of the product during transportation or the minimum firm level of security required for the determination of safety requirements.
Technical parameters:
|
||||||||||||||||||
Product Tags: iec testing equipment laboratory test equipment |
![]() |
6-Station Temperature Rise Tester Complies With IEC 60898-1 Standard Test Voltage <12V |
![]() |
IEC Test Equipment High-Precision Temperature And Humidity Control -70℃+150℃ Military-Grade Reliability Verification IEC 60068-2 4 Test Sites Stainless Steel Mat |
![]() |
Circular Saw Switch And Lower Guard Comprehensive Tester IEC 60745-2-5 Certified Equipment Safety Protection Linkage Detection System Source Factory Direct Supply |
![]() |
Impact Drill Durability Test Device IEC 60745-2-6 Certification Test Equipment Multi-axial Impact Life Tester Power Tool Durability Test Bench |
![]() |
HC9926 Plug Insulation Sheath Abrasion Tester IEC Test Equipment 999,999 Cycles 4N Precision Pressure Smart Home Appliance Safety Guard |
![]() |
HC9910C Temperature Rise Tester Professional IEC Test Equipment Accurate Control Of Electrical Safety Standards |