Appearance Change Of Lanterns Light Testing Equipment Adjusting Devices IEC60598-1 R500mm
|
Appearance Change Of Lanterns Light Testing Equipment Adjusting Devices IEC60598-1 R500mm Product information: The device is used to detect adjustment device, and confirm to the
IEC60598-1 clause 4.14.3. Technical parameters: 1. The test rate can be set, set ranging from 0.1 to 10 times / min. 2. The bending angle can be set , the swing range of vertical lines on both sides of 0-180°. 3. Rotation center height: 1200mm. 4. The maximum radius of gyration of the pendulum: R500mm. 5. Maximum stroke of stretching action: 0-650mm. 6. Action angle of rotation: 0-360°. 7. Test cycles can be set, the number of cycles range 1-999999. 8. The fixtures can meet a variety of samples within the standard range of testing needs. 9. Drive motor: Servo motor. 10. Controller: Mitsubishi PLC. 11. HMI: touch screen interface. 12. Guided whole English interface, easy to operate. 13. Load: with terminals, Externally connected to load (The load is optional,cost additional ).
Standard Information :
4.11.6 Electro-mechanical contact systems shall withstand the electrical stresses occurring in normal use. Compliance is checked by subjecting the electro-mechanical contact systems to 100 operations at a speed which corresponds to practical usage (an operation is either making or breaking the contact). The test is made with a.c. at rated voltage, and the test current shall be 1,25 times the rated current of the electrical contact system. The power factor of the load shall be approximately 0,6, unless a different rated current is marked for resistive loads, in which case the load power factor shall be unity. Where a luminaire is marked for both resistive and inductive loads, it shall be subjected to tests at power factors of both unity and 0,6. Before and after the tests, the electro-mechanical contact systems shall be loaded with 1,5 times rated current, and the voltage drop across each contact shall not exceed 50 mV. Following completion of these tests, the electro-mechanical contact system shall withstand an electric strength test made in accordance with 10.2. After the test, the samples shall show: – no wear impairing their further use; – no deterioration of enclosures or barriers; – no loosening of electrical or mechanical connections. For electro-mechanical contact systems, the mechanical test of 4.14.3 is carried out simultaneously with this electrical test.
Test on adjusting devices:
|
||||||||
Product Tags: light testing equipment led light tester |
![]() |
PLC Control Light Testing Equipment Conforms To IEC60598 Clause 4.14.3 Easy To Operate |
![]() |
IEC60598-2-8 Impact Tester For Handlamps With 400mm And 1000 Mm Impact Height |
![]() |
IEC62560 Clause 15 Circuit Figure 8 Light Testing Equipment For Non - Dimmable Lamp |
![]() |
Digital Control Lamps Light Testing Equipment Adjustment Devices Of Torsion And Bending Test According To IEC60598 |
![]() |
PLC Control LED Light Tester , 250v Self Ballasted Lamp Switches Endurance And Load Integrated Test System |
![]() |
IEC60669-1 LED Testing Equipment / Self Ballasted Lamp Switches Fully Automatic Breaking Capacity Endurance Tester |