Environmentally friendly water-based online PCBA cleaning machine 1. Fully automatic cleaning mode: The PCBA runs parallel on a
W600mm wide mesh belt, while the heated cleaning solution is
sprayed at high pressure in equal directions through the spray arm.
The entire process of rinsing (open-loop) and drying;
2. Full-process visualization: The tempered glass visual window
makes the cleaning process clear at a glance.
3. Scientific nozzle design (patented): It adopts a gradually
increasing distribution on both sides - for thorough cleaning, the
spray arm and nozzle are detachable.
4. The nozzle pressure can be controlled and adjusted within the
software: This solves the problem of collision and splashing of
small workpieces under high-pressure spray conditions during
cleaning.
5. The viewing window and entrance are equipped with photoelectric
protection to prevent the cleaning solution from splashing out. The
drop plate detection ensures its safety.
6. Comprehensive cleaning system: The standard dilution tank and
spray rinse tank are both equipped with heating systems, which
enhance the cleaning efficiency. Shorten the cleaning time and be
compatible
Run water washing or chemical cleaning for SMT; Thoroughly and
effectively clean the organic and inorganic contaminants such as
rosin and solder paste remaining on the surface of THT's PCBA.
7. The built-in filtration system for cleaning and recovery has a
function to compensate for the concentration of the cleaning
solution. The solvent section condenses and recovers for recycling,
reducing the amount of solvent used.
8. Body quality: The entire body is made of stainless steel,
resistant to acidic, alkaline and other cleaning solutions.
9. Configure a UPS reserve power supply for protection. In case of
any malfunction, it should have an emergency stop button and
leakage protection function.
10. It is equipped with a wind knife for wind cutting, which can be
adjusted left and right as well as up and down, maximizing the wind
cutting function for different products. | Content | Parameter | | Cleaning area dimensions | L:1000mm,W:600mm,H:90mm | | Equipment appearance dimensions | 3600MM*1960MM*1840MM | | Process flow | Plate feeding - Pre-rinsing - Rinsing 1- rinsing 21- final spraying
- air cutting 1-2-3- drying - plate discharging | | Capacity calculation | The speed of the mesh belt is adjustable from 0.1 to 1.5 meters per
minute, and the number of chains can be adjusted according to the
cleaning difficulty coefficient. | | Based on the cleaning difficulty coefficient, calculate the hourly
production capacity: PCBA length/mesh belt speed * number of
parallel arrangements *60 minutes | | Conveyor surface height | 950±50mm(adjustable) | | Direction of entrance and exit | Left in, right out (viewed from the front window of the crew) | | Exhaust volume (air extraction volume) | Approximately 36M³/Min; Exhaust port diameter: 250mm, 3 at the
front, middle and rear | | Weight | Approx 1,200 kilograms | | Power supply requirements | AC380/3P/50H; Total power: 90KW; Rated operating power: 50Kw/80A |
|
