Parking Lots Advertising Barrier Gate

New Design Advertising Barrier Gate 24V DC Brushless Motor Advertising Boom Barriers
 

 
Our Advantages:
 
1. 3second to 8 second open/close time adjustable;
2. Advertising DC brushless motor & 5 million MCBF;
​3. 5tension spring balance makes is heavy duty and more durable;
​4.Led lights with time swtich ,set a time for light on as you require;
5. Simplified design, easy installation and maintenance reduces your labor cost;
8.1year standard warranty, excellent after-sales service;
9. 24h*7d at your service to give you best support;

Technical Parameters:

1. Working temperature(motor): -30℃~+60℃

2. Rated Supply:24/100/240VAC,50/60Hz

3. Running speed:1.2sec to 3Sec(adjustable)

4. Rated power:160W

5. Driving Method:Servo motor

6. Humidity:≥85%

7. Remote control distance:≤100M(open,sunny weather)

8. IP Degree:IP54

9. Motor No-load Speed:1400r/min

10. Max Boom Length:3M-4.5M

11. Deceleration ratio:1:50

Equipment installation:

1. Please select the correct type of barrier gate according to the specifications of the pace,and then fix the

barrier cabinet with expansion bolts.

After determined the position,the barrier gate foundation should be done according to the site conditions,

and also make the cast-in-place basement for the non-concrete ground.

Select and commission spring:

The barrier gate is well-adjusted before delivery.For further adjustment,please follow below instructions.

The spring is stretchable one and the specification is as follows:

Diameter 4.0MM green color
Diameter 4.5MM red color
Diameter 5.5MM blue color
Diameter 6.8MM yellow color
Diameter 7.0MM white color

The spring length is subject to the actual product. Design changes will be notified separately.

Function setting parameter table

Adjust the Position of Barrier Arm

To adjust the position of the arm (for example, after exerting excessive force), please take the steps as below:

1. open the barrier gate door and remove the cover
2. Loosen the two fastening screws of the DZ-8 on the pendulum shaft with an M12 Allen key, so that the barrier arm can be repositioned by hand.
3. Calibrate the position of the barrier arm (horizontal position, as shown in Figure 1).
4. Use a hexagon wrench to re-tighten the two fastening screws

 
 
FAQ: