High Quality Bending Resistance Knives Strength Testing Machine
1.Product Introduction
The machine is used to test bending resistance of different knives.
2.Main Technical Paraments
Test weights | 10N±0.2N ( two) |
Balance block | 89mm×30mm×15mm (accuracy ±0.03mm) |
Plastic parallel ruler | 380mm×8mm |
Scale plate | 180mm×350mm |
Acrylic cover | 530mm×290mm×93mm |
Out dimension | (L×W×H) 607mm×386mm×470mm |
Fixtures | |
3.Test Procedure
1.Clamp the handle of the sample to be tested in the pivoted clamp.
Position the handle in the clamp so that during the test the tip of
the blade or craving fork prongs and the end of the handle will
remain in essentially the same horizontal plane.
2.Clamp the blade , or prong tip in the unloaded tip clamp, ensure
that the hand lever is removed from the apparatus and set both
scales to zero.
3.Connect the test load to the tip clamp put on the lever and
rotate the shaft of the pivoted clamp until the tip clamp just
rises from the guild rails maintain it in this position for 10 s.
Return the hand lever to a position of rest and remove the hand
lever, remove the load from the tip clamp and read off the angle of
deflection. (angle of permanent deformation)
Turn the sample over and repeat the test in the opposite direction.
