High immunity Detector DSP Automation Needle Detector Machine 1.Description:
High immunity Detector DSP Automation Needle Detector Machine detection of thick material and thin material, display of the
positions of broken needles and scrap iron in an object being
detected for facilitating the finding of the broken needles of
operators, automatic return of object to be detected, automatic
start-up, once switch startingfir each working stage, a power
utilization system capable of stopping the machine five minutes
after no-load operation, power and money conservation, power
utilization safety protection, great popularity among customers.
2.Applicable Industries:
High immunity Detector DSP Automation Needle Detector Machine is used to garment, textile, bra, baby product, shoes, socks,
gloves and soon, for detecting impurities such as needle points,
pins and scrap iron in products, preventing metal pollution of the
products and guaranteeing product quality.
3.Technical Parameters: | Detection width | 400mm | | Detection height | 100mm | 150mm | 200mm | 240mm | 280mm | 320mm | | Detection sensitivity Fe (iron) | FeΦ1.0mm | FeΦ1.2mm | FeΦ1.5mm | FeΦ2.0mm | FeΦ2.5mm | FeΦ3.0mm | | speed | 25m/min | | Power supply | AC220V±10% 50Hz | | Power | 60w | | Weight | 120KG | | Dimensions l*w*h (mm) | 1250*800*850mm |
Features:
1,Neuest design with luxury modern looking streamline ABS cover.
2,Broken readle location indicater (8 sector).
3,Appear the passing sum.
4,Including extra-thick and exera-thin inspection function.
5,Belt correct device.
6,Automatically startup function.
7,EP design of autematically stop function after each 10 minutes
empty rumming.
8,Vision and sound warning,and automatcally run back function.
Composition structure
1, the detection sensor (probe)
2, the circuit control system
3, the electrical machine
4. The conveyor belt
5, the rack
6, the wing housing
7, drive shaft
8. Optical Infrared emitters
9, the fixed foot
10, a control panel
Operating procedures
1) Check the machine probe, the conveyor belt, whether the debris,
tools, etc., should be removed if the following between the probe
and the surface of the conveyor belt below the window pallet.
2) Detection
3) the subject goods should not be too much, can not exceed the
detection channel, if a collision detection probe may cause false
alarms.
4) If the machine detects the abnormal sound, should immediately
stop inspection, troubleshooting and then tested.
5) detection probe should remain very stable, does not allow the
probe stack anything allowed by the probe as a rest support, press
the "Run" button to start action should be light, to prevent false
alarms due to vibration.
6) the machine to vibration or power fluctuations, and occasionally
there will be an alarm phenomenon is normal, not a fault.
7) After each test should be promptly click the "Power" button and
unplug it off.
Needle machine maintenance
1. Each test is completed, the conveyor belt response, probe
maintenance on the machine removed the foreign body. Special
attention probe window below the surface of any debris between the
pallet and the conveyor belt is not allowed.
2. Rinse detector is not allowed to remove the debris. To ensure
the conveyor belt, the probe control box dry.
3. When summer temperatures or a long time without much prior to
use shall conveyor, pallet accumulation of moisture on the
electrical box to dry before boot.
4. Regularly check the machine transmission parts refueling, if
loose fastening screws should be tightened.
5. Motor Maintenance
The picture of metal detector:
|
