Safety Parking Gate System RS485 Traffic Light Interface IP66 Water-Proof Explosion-Proof

PRODUCT DESCRIPTION

This is  Explosion-proof barrier gate. This product is a typical mechatronics product with the characteristics of small volume, low noise, high efficiency, wide speed regulation and small steady-state speed error.

The fourth generation reducer is special for barrier gate,with optional multi speed ratio, stable operation, and the customized gear has higher transmission efficiency and high stability, which is more and more respected by the market. It adopts the latest mold design technology, die casting manufacturing technology, and brushless control speed regulation technology. The arm can be interchanged quickly. Non clutch design is more convenient to use, and the machine core adopts gear transmission that speed is fast.The arc-shaped curved crank three-link structure makes the arm work fast and stable. Convenient maintenance and long service life.

Applicable places:

gas stations, gas plants, natural gas plants, kerosene cave entrances, chemical factories

hazardous material warehouses, etc.

FUNCTIONS

1. The running speed can be adjusted from 1.5s to 3s, 2.5s to 8s.

2. Arm direction can be quickly interchanged.

3. Open the barrier gate by motor wheel when power off, automatically reset after power on.

4. Curved crank arm three- link movement structure, the operation is stable.

5. Wireless remote control for open/close.

6. Auto reverse function(force adjustable).

7. Infrared photocells connector is available.

8. Loop detector connector is available.

9. Well-integrated with car parking system equipment,with wire control(must be switch signal).

10. Connector for traffic light(AC220V, power less than 40W).

11. Offering dry contact signal for car parking system(COM,NC,NO).

12. Auto-delay when closing(adjustable).

13. RS485 or CAN network communication interface(no need to install module).

14. Counting interface

15. 24V backup battery interface(Can be charged by using solar energy, optional)

16. Arm open when power off ( add backup battery, optional)

17. Anti-collision alarm device( optional)

TECHNICAL SPECIFICATIONS

INSTALLATION STEPS

1. Please select the correct type of barrier gate according to the specifications of the pace,and then fix the barrier cabinet with expansion bolts.

After determined the position,the barrier gate foundation should be done according to the site conditions,and also make the cast-in-place basement for the non-concrete ground.

2. Select and commission spring

The barrier gate is well-adjusted before delivery.For further adjustment,please follow below instructions.

The spring is stretchable one and the specification is as follows:

Diameter 4.0MM green color
Diameter 4.5MM red color
Diameter 5.5MM blue color
Diameter 6.8MM yellow color
Diameter 7.0MM white color

The spring length is subject to the actual product. Design changes will be notified separately.

3. Adjust the Position of Barrier Arm

To adjust the position of the arm (for example, after exerting excessive force), please take the steps as below:

3.1 Open the barrier gate door and remove the cover
3.2 Loosen the two fastening screws of the DZ-8 on the pendulum shaft with an M12 Allen key, so that the barrier arm can be re-positioned by hand.
3.3 Calibrate the position of the barrier arm (horizontal position, as shown in Figure 1).
3.4 Use a hexagon wrench to re-tighten the two fastening screws