Phased Array Type A Calibration Block used to wedge delay
calibration,sensitivity calibration,performing DAC/TCG
Specifications:
Calibration blocks is an important supplementary material in the
Ultrasonic testing, used to calibrate the sensitivity of the
ultrasonic flaw detector and ultrasonic probe. Our testing block is
certificated by the authority of the state depeartment. Our
products include: domestic standards UT blocks, European standard
UT block, NDT block, hexagonal testing block, and so on. Processing
of the special specifications UT block.
The Phased Array “Type A” Calibration Block is used during the initial setup and calibration of a phased array
ultrasonic unit. This block can be used to perform tasks such as
beam angle verification, calibration for wedge delay, sensitivity
calibration, performing DAC/TCG, and more. This block has similar
dimensions to an IIW-Type Block, but has been specially-engineered
for phased array applications.
Blocks include both 100.0mm and 50.0mm radii, (19) through holes at
1.0mm diameter, (1) through hole at 2.0mm diameter, (4) FBHs at
2.0mm diameter x 2.0, 4.0, 6.0, and 8.0mm deep, (4) FBHs at 4.0mm
diameter x 1.0, 3.0, 5.0, and 7.0mm deep, (3) FBHs at 2.0mm
diameter x 3.0mm deep machined into the 50mm radius, and (4) EDM
notches at 0.1, 0.2, 0.3, and 0.4mm deep x 0.5mm wide x 25.0mm
long.
Block dimensions are 25.0mm thick x 100.0mm tall x 300.0mm long.
1018 carbon steel, LY12/6063/7075 aluminum,304 stainless
steel,duplex stainless steel optional
