Wireless Wifi Module Shields V2.1 For Arduino , Shield For Arduino

Wireless Wifi Module Shields V2.1 For Arduino , Shield For Arduino

Description:

The shield uses WizFi210 which is a low power-consuming WIFI module which is applied with dynamic power management technology. When the WIFI module needs to be on but not work, it can be set to standby mode a low power mode, and the module just needs to be woken up when it has to work.

The WIFI wireless module is based on WizFi210. It provides the bridging from TTL serial port communication to IEEE802.11b/g/n wireless communication. So any device with TTL serial ports can easily be connected with this WIFI module and controlled and managed remotely through a wireless network. Different kinds of communication protocols and encryption algorithms are integrated with the module. The architecture enables you to easily integrate this module into any projects for Arduino.

Specification:

- Wifi Chip: WizFi210;
- Radio Protocol: IEEE 802.11b/g/n Compatible;
- Supported Data Rates: 11, 5.5, 2, 1 Mbps (IEEE 802.11b);
- Modulation: DSSS and CCK;
- RF Operating Frequency: 2.4 - 2.497 GHz;
- Antenna Options: Chip antenna and U.FL connector for external antenna;
- Networking Protocols: UDP, TCP/IP (IPv4), DHCP, ARP, DNS, HTTP/HTTPS

- Power Consumption(Typical): Standby = 34.0 µA Receive = 125.0 mA Transmit = 135.0 mA;
- RF Output Power (Typical): 8dBm ± 1dBm;
- Security Protocols: WEP, WPA/WPA2-PSK, Enterprise, EAP-FAST, EAP-TLS, EAP-TTLS, PEAP;
- I/O Interface: UART,WAKE, ALARM, GPIOs;
- Power Source: 3.3V;
- Dimensions(except Antenna): 59mm x 54 mm x 11mm

-Data rate: 54Mbps-1Mbps

-Data flow transmission rate: 11,5.5,2Mpbs (802.11b)

- Shipping List:
- WiFi Shield V2.1 for Arduino (1 unit);
- Antenna (1 unit).

Factory Pictures

Competitive Advantage:
 

1. Convenient & Friendly Customer Service

2. Low Prices Direct From Factory Suppliers
3. Fast Delivery Around The Globe. 
4. High Quality With Global Standards. 
5. 3 year factory warranty
6. Safe shipping way and payment